WAD III ER VR0
Replacement cover – hot-galvanized
740 x 740 mm | 250 kN
Without locking device
WAD III ER VR2
Replacement cover – hot-galvanized
740 x 740 mm | 250 kN
2 locking devices
WAD III ER VR0
Replacement cover – hot-galvanized
740 x 740 mm | 400 kN
Without locking device
WAD III ER VR2
Replacement cover – hot-galvanized
740 x 740 mm | 400 kN
2 locking devices
Insert frame
High-grade steel
With glued in noise insulation tie
To reproduce the banking rim
Foam rubber
Square profile
Measurement:
15 x 13 mm, 3.2 linear meter per cover
15 x 11 mm, 3.2 linear meter per cover
Gas pressure springs
High-grade steel
1000 N or 750 N
Loose-pin hinges
Left and right
Gas pressure spring with locking
Extension force: 200 – 2500 Newton | Progression: 40%
Piston rod: Diameter 14 mm, W. 1.4305 / AISI 303
Pressure pipe: Diameter 28 mm, W. 1.4301 / AISI 304
Extras: Plug-in fuse
Retrofit hinges
Left and right
Screw set
Set of screws to change the cover
BG latching
For WAD III E
Without limit stop
Milled on one side
Diameter 80 mm
BG latching
For WAD III E S
With limit stop
Milled on both sides
Diameter 80 mm
BG latching
For WAD III M
With limit stop
Milled on one side
Diameter 90 mm
Shear latching
For WAD III E S
Flanged plug-in unit K
In different versions
Flanged plug-in unit H
In different versions
TAG
In different versions
BG insulting joint
Internal thread and external thread
Height 53 mm
Sizes: 2 and 3 inches
Insulting ferrule
Sizes:
• 69,5/60,5 x 30 mm
• 99,5/89,4 x 30 mm
BG Reed sensor carrier
Sizes: 2 and 3 inches
Key to open EU
with socket wrench
AVS repair kit
These parts are only available as a complete repair kit:
AVS-Lever | AVS-Handlever bottom part | AVS-Shaft at the top | AVS-Bolt | AVS-Double leg spring | Leg spring left-wound | Leg spring right-wound | Cylinder pin 3×16 DIN 7-A2 | Cylinder pin 3×20 DIN 7-A2 | Cylinder pin 6×20 DIN 7-A2 | Roll pin 3×16 DIN 1481 A2 | Lock washer for shaft 6 DIN 6799-A2 | Compression spring 25705 1.4310K DIN 17224 | O-ring seal for AVS 2-inch-cover NBR black | O-ring seal for AVS 3-inch-cover NBR black | AVS 2- and 3-inch Lever shaft | AVS 2- and 3-inch handlever | AVS 2- and 3-inch Lever arch | AVS 2- and 3-inch Axis
In the retrofitting area the Lübbering Umwelttechnik GmbH offers the complete range of spare parts of the HSB-dome shaft covers!
Contact for these products:
Email: mki@luebbering-umwelttechnik.de
Email: sv@luebbering-umwelttechnik.de